Enterasys-networks Wireless Ethernet Adapter I Manuale Utente Scaricare il pdf (Pagina 52)

Flow Control

5-6 General Serial Configuration

Flow Control Configuration

To configure the Ethernet Adapter flow control, perform the following steps:

1) Click on the Flow Control tab. Figure 5-3 shows the Flow Control tab page

with the default settings

2) Check the flow control settings of the device that you are connecting to the

Ethernet Adapter. Change the Ethernet Adapter settings to match those of the

connected device by clicking on the corresponding buttons. The flow control

and the device settings must match. For example, if you are connecting to a

device that is using RTS/CTS hardware flow control, set the Ethernet Adapter

hardware flow control settings to RTS/CTS.

Figure 5-3: Flow Control Tab Page

Serial Packets

The parameters on this tab page control the serial to network packet conversion process.

Most users will not need to change the Serial Packet Parameters. These parameters control

the way that data received on the serial port is divided into Ethernet packets.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 87 88

Nessun commento

Enterasys-networks Wireless Ethernet Adapter I Manuale Utente Pagina 52