Enterasys Networks VH-8TX1MF Manuale Utente Scaricare il pdf (Pagina 36)

22 Installation VH-8TX1UM/VH-8TX1MF

10Base-T/100Base-TX Ports

The 10Base-T/100Base-TX ports use RJ-45 connectors. Figure 2-4

shows an RJ-45 connector being inserted into a port.

Figure 2-4. Inserting an RJ-45 Connector into a Port

The ports on the base unit are wired with the MDI-X function

implemented. These ports interface to UTP cabling for

connection to

10Base-T or 100Base-TX network segments or end-stations.

These UTP

connections meet the requirements of ISO 8877, specified by 10Base-T,

Section 14 of the IEEE 802.3 specification. Workstations or servers can

be connected to these ports using standard straight-through wired cables.

For connections to other switches or hubs, use an MDI port on the other

device. If an MDI port is not available, a crossover

cable may be

necessary (refer to “

MDI/MDI-X Crossover Cable Wiring” in Appendix A).

See Table A-2, “10Base-T/100Base-TX Pinouts,” for 10Base-T/

100Base-TX connector pin assignments.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 53 54

Nessun commento

Enterasys Networks VH-8TX1MF Manuale Utente Pagina 36